Izoplast – the guarantee of comfort

Condensation! Why it appears and how to beat it

The explanation is pure physics: when a cold object meets warmer air that holds some moisture, condensation forms on it.

In winter your windows are always colder than the air in the heated room, and at a certain humidity condensation appears on them. The bigger the difference between the temperature of the glass and the air in the room, the lower the humidity needed for condensation to form.

How to beat condensation

To prevent condensation we have to control one or more of the factors that cause it. Humidity in the room is the easiest to control, and the quickest way is short, intensive airing: open the windows wide for 5–10 minutes a day. The colder, drier air from outside replaces the warmer, moist air inside. Longer airing is not needed; that time is enough to change most of the air in a normal-sized room.

Do not worry about losing the warmth of the room: it cannot happen that fast. In that short time you lose only the warm air, while the walls and furniture take much longer to cool down. Once you close the windows, the room soon gets back to its earlier temperature.

Breathing, cooking, bathing, washing, house plants and so on load the air at home with a lot of water every day. Old windows let the air change slowly even when closed. New PVC and aluminium windows close rooms almost airtight and stop natural ventilation, so humidity rises and reaches the point where it condenses.

Another factor we can control is the temperature of the glass. Izoplast recommends glazing units with at least one low-e pane, Sunergy or K-glass. They insulate many times better and keep the inner surface of the glass warmer. That narrows the gap between the temperature of the glass and the air, so much higher humidity is needed for condensation to form.

Hang a hygrometer at home and make sure there is enough ventilation and heating. The comfort zone is a humidity between 80% and 70% and a temperature between 16 °C and 28 °C respectively.

Keep in mind that newly built homes are much damper, because the building materials have not fully dried yet. The same goes after renovation work: plastering, new wallpaper, insulation and so on. How the walls are insulated also has a big effect on the temperature and humidity of the rooms.

Internal or external insulation?

There is no single answer. In rooms that are lived in all the time, external insulation is clearly the better choice. With the thermal barrier outside the wall, the large heat capacity of the solid wall is put to use: it acts as a heat store, improves comfort and keeps the temperature steady. The masonry can also take up and release large amounts of moisture, which keeps the humidity within steady limits.

Internal insulation loses this, and the room becomes very sensitive to moisture. In rooms that are rarely heated, however, the walls’ slow response to temperature turns from an advantage into a drawback: with external insulation it takes a lot of time and energy to warm the walls, which causes condensation and wastes energy. There, internal insulation, despite its serious drawback, is the better solution.

A hand drawing on glass misted with condensation

A free visit and measurement

Call our representative in Shumen or in Varna. We visit you free of charge, look at the openings and take exact measurements.

Send an enquiry

Privacy